TrekBuddy

[everga]

first I want thank you for trekbuddy. I like it .

In the new version .93 I have a problem with map switching on a big Atlas.
I create the atlas Level 1 to 16 ( 60kx60k points in Level 16) with current version of MobileAtlasCreator. Wenn I use the default Map size 32k the handy (N79) is verry slow (near by not useable) on switching from one tile to an other at (level 14 - 16). So I tryed it at a lower map size 16k and 8k. At this sizes the tile switching workes much better, but when it has to change the "map directory" the handy changes the layer to the first level (14 or 13) with only one directory.

Directorystructure
D/cr.tar
D/K8/K8 0
D/K8/K8 1
...
/K8 13
/K8 14 0
...
/K8 14 3
/K8 15 0
...
/K8 15 15
/K8 16 1
....
/K8 16 63

Example: If I load the Atlas with K8 14 0 I get the right tile displayed. I can then move south or east with cursor and all works well and "fast" until I reach the border of K8 14 0. But then it did not switch to the map K8 14 1 (south) or K8 14 2 (east) it switch to the map K 13 instead. The same happend if I start with K8 15 x or K8 16 x.

The old version I used before Trekbuddy und TrekbuddyAtlasCreator ( from spring 2009) does not have this switching problem.

I do not know it that switching problem is a problem of Trekbuddy or a problem of the new directory structure MobileAtlasCreator.

perhaps I am to stupid and I do a mistake I do not see yet.

It has nothing to do with the spaces in the names of the map. I changed them to _ and have the same Problem

Thanks in advance for any help

Best wishes

Andreas