TrekBuddy

jvoges · Joined: 26 Aug 2007 Posts: 8

Hi everybody,

I'm using Trekbuddy with a SonyEricsson W950i.
When I switch maps I get the following error message very often:

Failed to use map.: java.lang.NullPointerException: 0

Just before the message shows up I get the question, whether I want to use the map as default. This question disappears then immediatley.

Any solution for this?

thx in advance,

Jörg

kruch · Site Admin Joined: 02 Jul 2006 Posts: 5083

The "Use as default map" disappears without your intervention?? Are you switching maps in atlas or loading standalone one? And, does this happen when GPS is connected?

jvoges · Joined: 26 Aug 2007 Posts: 8

I'm switching maps in the Atlas-mode, but also switching atlases ...
Then, even if GPS is connected, sometimes the question "Use ase default altas?" appears and a second later I get the error message.

After pressing "OK" on the error message sometimes "event cleanup" appears at the very top and then it works ...
Just now had the same problem again and another error message shows up. Then I can only shut down the software ... Sad

I tried everything to reproduce the error, but so far I could not figure out, when it appears and when not.